The 3688 purifier can be used for water applications. Some everyday uses can range from: purifying your drinking water at home, cleaning meats, fruits, and vegetables, bathing.
Special Features
- Functional Timer with 18 Settings for Different Applications
- Lightweight and Portable
- Internal Memory -- Remembers the Previous Setting in case of Power Outage
- Wall Mountable or Standalone
- Optional Oxygen Port for Oxygen Tank or Oxygen Concentrator
Typical Applications
- Water Purification with Use of a Filter
- Drinking-Water by Glass or Gallon
- Small Pools
- Bathwater
- Dental Hygiene
- General Disinfectant
- Treat Fruits and Vegetables
Technical Specifications
| Model: | Model 3688 |
| Power: | 220/240 VAC, 50/60 Hz |
| Wattage: | 16W |
| Ozone Output: | Up to 800 mg/hour |
| Weight: | 2.0 lbs / 0.9 kg |
| Dimensions: | 6.4 L x 3.5 W x 7.7 H |
Parts Included
- 3688 Ozone Generator
- User's Manual
- Two Sets of 36 Inch Long Polyurethane Tubes for Ozonation
- Two Short Spare Tubes for Internal Replacement if Needed (1.75" and 2.75")
- Two Fine White Diffuser Stones
- One Coarse Grey Diffuser Stone
- Spare Fuse
How It Works
- Plug the 3688 Ozone Generator into an electrical outlet.
- Attach one end of the tubing (36 inches long) into the ozone outlet on the side of the 3688 Ozone Generator and attach a stone diffuser onto the other end of the tube.
- Extend the tubing so that the diffuser stone and the 3688 Ozone Generator are as far apart as possible.
- Push in the power button located on top of the unit to the ON position.
- Press the plus (+) button to select the desired function setting from the table for the desired application time.
- The minus (-) button will step down the setting numbers sequentially.
For Oxygen Air:
The ‘Oxygen In’ port on the side of unit can be hooked up to an oxygen tank or oxygen generator of your choosing. Keep in mind, to hook up an oxygen tank or oxygen generator you will need a regulator that will reach 5 PSI or lower.
- First, you will connect one end of your tubing to your tank (or concentrator) and then attach the other onto the left side of the 3688 Ozone Generator.
- You will then need to set your regulator to 2.5 LPM or 5 PSI.
- Once the regulator is set you can turn on the oxygen flow and let it run for 10 seconds.
- After the 10 seconds is up turn on your 3688 Ozone Generator to appropriate timer function.
- Once the timer function has completed you will need to let the oxygen run for another 10 seconds to clear the remaining ozone from the ozone tube.
- After 10 seconds, you can turn off the oxygen flow.
This unit boasts an airflow rate of approximately 1 L while using the internal air compressor. This will output approximately 2.5 mg of ozone. Please allow a 10% - 15% difference in values to account for slight differences in conditions.
Please Note: In case of exposure, remove to fresh air. If inhaled, ozone can damage the lungs.
Please note: Keep away from natural gas, oil, gasoline, or other flammable chemicals as it could be an extreme fire hazard.